Drive Rite Semi Air Kit Ford Transit Single Rear Wheel
Drive Rite Semi Air Kit Ford Transit (Single Rear Wheel) 330 - 350
The Drive Rite Semi Air Kit for Ford Transits is a complete kit including both the air suspension system i.e. bellows, piping and valves as well as the additional gauge and controls.
Suitable for Square Axle / ABS Ford Transits Single Rear Wheel only (Type 330 - 350)
Note: Product Picture above shows a Ducato Kit but the Transit is very similar
FIRESTONE Air Bellows used in this air suspension kit
Designed to fit the Ford Transit Single Rear Wheel (Square Axle / ABS) this kit is simple to install and can be undertaken by any DIY'er.
Installations typically require no drilling
Reduces suspension fatigue and bottoming out while increasing comfort and stability
Enables side to side leveling to allow for off centre loads
Mounts between chassis and original suspension
Designed for Light Commercial Vehicles, 4x4s, Motor homes and many more
The original suspension is not removed. The semi-air systems are designed to work together with the original suspension
The Driverite air suspension can be adjusted to bring the vehicle to ride height regardless of the load (Do not exceed the Gross Vehicle Weight-GVW)
All semi air kits come with two inflation valves that allow for manual inflation in a similar fashion to inflating a car tyre at a service station.
The dual gauge and inflation valve kit allows the operator to monitor the pressure in each airspring through the use of a dual needle gauge. Inflation and deflation of the air suspension is brought about using the two inflation valves in a similar fashion to inflating a car tyre at a service station.
The basic compressor and single gauge kit allows the operator to adjust the pressure in the airsprings using the paddle switch. There is no need to drive to a service station as the compressor feeds directly into the airsprings. This system inflates both airsprings equally.
The compressor and dual gauge kit allows the operator to adjust the pressure in each airspring individually using the two paddle switches. There is no need to drive to a service station as the compressor feeds directly into the airsprings. This system inflates each airspring individually allowing the vehicle to be levelled side to side or front to rear allowing for off centred loads.
The automatic single height sensor kit will always keep the vehicle at a set ride height. It is load independent and there is no need for the operator to monitor the pressure in the airsprings as the single height sensors built-in ECU will take care of this.
The air bellows can be inflated independently to balance the motorhome depending on loading situations.
No Customer Reviews
Want to read more? See all customer reviews...
Drive Rite Semi Air Kit Ford Transit Single Rear Wheel Reviews
No Customer Reviews
Do you own this product? Write a review!
Motorhome Accessories and Caravan Accessories supplied and fitted - (TRANSITSINGLEDRVRITE)
A ticket will be automatically created in our online helpdesk to track your enquiry through to conclusion.